Software suppliers

Process for connection

Providers of end-user solutions (SWS) must follow the following process for connection to NoMVS:

1. Contact Nomvec and inform them about their solution
2. Create user on the SWS portal
3. If necessary, have a start-up meeting with Nomvec
4. Develop and test the integration in line with the process described in the SWS portal (NMVS Software Suppliers Portal, developed by Arvato)
5. Conduct baseline tests (downloaded from the SWS portal)
6. Approved for production setting

Requirements

To ensure that the NoMVS integration maintains a high standard of quality and that the information presented to the end-user is accurate, Nomvec has established certain requirements for the development of end-user software.

These requirements cover the following areas:

• how the end-user system should handle the scanning, reading, and display of information contained in the 2D code printed on the pack
• test of the integration
• documentation

The requirements, along with further details, are set out in the document “Requirements to an end-user software with integration to NoMVS – direct or indirect,” which can be downloaded below.

Baseline testing

All documentation that is necessary for the supplier in the development and test run is published on the SWS-portal. During development, test sets can be generated and the tests can be completed as required. When development is finished, the “Baseline Test Pack” must be downloaded from the SWS-portal and the tests must be done. The result of these tests is the basis for Nomvec’s approval of the supplier’s integration with NoMVS.

The test sets downloaded from the SWS-portal is done towards the Sandbox environment. This environment is connected to the EU-HUB-Mock, both of which are production identical at all times.

A prerequisite for the solution to be approved is that the supplier is registered in the Brønnøysund Register Centre.